|
|
|
|
| Security Consoles/Voice Dialers |
|
|
HomeX-10 ProductsSecurity & SurveillanceSecurity Consoles/Voice DialersAbsolute Beginner's Guide to Home Automation |
|
|  | | | Customer Reviews: | | | Average Customer Review: ( 2 customer reviews )
Write an online review and share your thoughts with other customers.
Most Helpful Customer Reviews
22 of 23 found the following review helpful:
 make an overall plan first Sep 03, 2005
By W Boudville
The book is mostly about developing nifty controls using X10. In this field, X10 is by far the dominant controller. Soper explains why, by describing numerous varied ways to have it control items in the typical household. It is probably simpler to read this book than thumb through the official X10 documentation. Soper does not require that you have a deep technical background to implement the book's methods.
Aside from the specific automation methods, he also offers a chapter on planning what you might want to and be able to automate in your home. Here is where you can start, to devise an overall plan, in a top-down fashion, rather than plunge into hooking up one or two gadgets. That can come later. The chapter is good for helping decide, especially within the constraints of a budget, which surely applies to many readers.
The book also points out a strong point about the latest X10 devices. These can be wireless, hugely easing installation. No awkward and unsightly wires trailing along your floors and walls.
5 of 5 found the following review helpful:
 Good, but contains a VITAL mistake Oct 12, 2008
By Michael McAuliffe
Maybe it's the copy I'm reading, but on page 80, the author is completely (and quite possibly dangerously) wrong about the following point:
"If you are installing a light switch that uses a neutral wire ...
it is essential that you determine which wire is the load wire (carries
current at all times; also called the hot wire) and which is the
line wire (carries current only when the switch is off; also called
the switched-hot wire)"
NO! It should read as follows (emphasis on changed words):
"If you are installing a light switch that uses a neutral wire ...
it is essential that you determine which wire is the *LINE* wire (carries
current at all times; also called the hot wire) and which is the
*LOAD* wire (carries current only when the switch is *ON*; also called
the switched-hot wire)"
In the very next section he uses the correct terminology but that is most definitely a serious mistake in the book that could have serious consequences should somebody confuse the two.
|
| | |
|
|
|
|
|
