PSC01 X10 Powerflash Interface By X10 Pro

Wire the output from your existing security system to this Burglar Alarm Interface and set the module to Mode 2. When your alarm trips, the PowerFlash Module can cause your indoor and outdoor X10 lights to flash! This not only scares your intruder but also makes your intruded house quickly visible to others (neighbors, police enroute, etc.). Use the PowerFlash Module with any input to activate a Beeper (such as the XPPUM01 Universal Module or XPPHH02 Chime Module) or as input to a smart home automation system such as the HomeBase Whole House Controller. The PowerFlash will also activate the Powerhorn Remote Siren. Dry contact or low voltage (6-18VDC) activates X10 Signal. For example, turn off the vacuum when doorbell rings, send a signal when the garage door opens, or mute the TV when phone rings. The PowerFlash Interface sends an X10 signal in response to a motion detector, photocell, magnetic window switch, you name it! If it's got output, it can probably trigger the PowerFlash. The module can be activated by a low voltage (6-18VDC) or a dry contact (no voltage) switch closure. Once activated the module sends an X10 signal. The module becomes deactivated when the low voltage is removed or the dry contact switch is opened.

• 120 VAC, 2 Watts

• 60 Hertz

• 6 Volts DC minimum; 18 Volts DC maximum

• Indoor use only