Smarthome 2000SC LampLinc Essential X10 Lamp Module, White

The LampLinc Essential does everything traditional lamp modules do, but without the unattractive, boxy look and technology that pre-dates the first personal computers. The clean, smooth lines of this remote lamp dimmer easily blend into the wall while the modern electronics inside carefully listen to the powerline for the faintest of signals. The LampLinc Essential couldn't get any easier to install; simply plug it into your outlet. LampLinc Essential operates and responds to all the standard X10 signals including On, Off, All Lights On, All Units Off, as well as Bright and Dim. This makes it fully compatible with all home automation programs like ActiveHome, HouseLinc™ and the original home automation computer interface, the CP-290. LampLinc Essential works with all these programs by coming on at full brightness (unless Resume Dim mode is enabled). Unlike traditional lamp modules, which use old-fashioned address wheels that are difficult to adjust and sometimes fail, LampLinc Essential's X10 address is set electronically with any standard X10 transmitter. Just send the address three times in a row within 30 seconds of being plugged in. After the third address is received, the lamp that's plugged into it will turn on to indicate it has successfully learned the signal. And don't worry about LampLinc Essential forgetting its address during a power failure; EEPROM memory will retain the address you programmed. The LampLinc Essential is built upon the same platform and contains the nearly the same electronics found in the original LampLinc. The maximum wattage for the LampLinc Essential is 300 watts, as compared to 400 watts in the original LampLinc series. LampLinc Essential also lacks the pass-through outlet, Status LED, and Set button for programming the address.

• Our most cost-effective lamp module

• Electronically set codes will stay in memory even if unplugged

• Easy to install - just plug it in

• Resume dimming feature

• 300 Watt maximum load